LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2012 >> Sedona LX >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Airbag Modules & Clock Spring >> Curtain Airbag (CAB) Module >> Repair Procedures >> Installation

Repair Procedures: Installation

CAUTION:
  • Ensure that the harness is installed and routed properly to prevent damage to the wiring.
  1. Disconnect the negative (-) cable from battery and wait for at least three minutes.
  2. Remove ignition key from the vehicle.
  3. Install a Curtain Airbag (CAB) on the mounting bracket.
  4. Tighten the CAB mounting bolts (13 EA).

    Tightening Torque (CAB Mounting Bolt)

    : 1.9 ~ 2.7 kgf.m (18.6 ~ 26.5 Nm, 13.7 ~ 19.5 lb.ft)

    CAUTION:
    • Never twist the airbag module when installing it. If the module is twisted, airbag module may operate abnormally.
  5. Connect the CAB connector (front & rear).
  6. Reconnect the battery negative cable.
  7. After installing the CAB, confirm proper system operation:
  1. Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
scientia non olet · About LEMON Manuals