LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2011 >> Soul Base >> Repair and Diagnosis (Single Page) >> Restraints >> Air Bag, SRS >> Supplemental Restraint System Control Module & Sensors >> SRS Control Module (SRSCM) >> Components and Component Locations >> Installation

Components and Component Locations: Installation

  1. Remove the ignition key from the vehicle.
  2. Disconnect the battery negative cable and wait for at least three minutes before beginning work.
  3. Install the SRSCM with the SRSCM mounting bolts.

    Tightening torque (SRSCM Mounting Bolt): 

    7.8 ~ 9.8 Nm (0.8 ~ 1.0 kgf.m, 5.7 ~ 7.3 lb.ft)

    NOTE: Use new mounting bolts when replacing the SRSCM after a collision.
  4. Connect the SRSCM connectors (A) and (B) by pushing the lever (3) and lock (1) completely.
    Fig 1: Identifying SRSCM Connectors, Lever, Lock, & Ground Points
    G06524839Courtesy of KIA MOTORS AMERICA, INC.
    NOTE: When installing the airbag wiring harness, ground points (C) must be installed.
  5. Install the floor console. (Refer to CONSOLE )
  6. Connect the DAB, PAB, SAB, CAB and BPT connectors.
  7. Reconnect the battery negative cable.
  8. After installing the SRSCM, confirm proper system operation:
    1. Turn the ignition switch ON. The SRS indicator light should be illuminated for about six seconds and then turn off.
scientia non olet · About LEMON Manuals