LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2011 >> Soul Base >> Repair and Diagnosis (Single Page) >> Engine Performance >> Testing & Diagnosis >> Engine Control System Diagnosis (1 Of 2) - 1.6L >> DTC P0135: O2 Sensor Heater Circuit (Bank 1/Sensor 1) >> Scantool Diagnostics >> Monitor Scantool Data

Monitor Scantool Data

  1. Connect scantool to DLC (Data Link Cable).
  2. Warm up the engine to normal operating temperature.
  3. Monitor "HO2S (S1)" parameter on scantool.
    Fig 1: Monitoring Oxygen Sensor (S1) Parameter On Scantool
    G06522592Courtesy of KIA MOTORS AMERICA, INC.
  4. Is the "HO2S (S1)" parameter operating correctly?

    YES 

    Fault is intermittent, caused by poor contact in the sensor's and/or ECM's connector, or was repaired and ECM memory was not cleared. Thoroughly check connectors for looseness, poor connection, ending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure

    NO 

    Go to "TERMINAL & CONNECTOR INSPECTION " procedure.

scientia non olet · About LEMON Manuals