Repair procedures: Replacement

WARNING: This page is about a different car, the 2011 Hyundai Tucson. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

When removing and installing the hood, an assistant is necessary.
Be careful not to damage the hood and body.
When removing the clips, use a clip remover.

Remove the front bumper.
(Refer to the FRONT BUMPER .)
Loosen the mud guard mounting screws.

Fig 1: Identifying Mud Guard Mounting Screws
Courtesy of HYUNDAI MOTOR CO.
After loosening the mounting screws and clips, then remove the side sill garnish (A).

Fig 2: Identifying Side Sill Garnish
Courtesy of HYUNDAI MOTOR CO.
After loosening the mounting screws, then remove the front bumper side mounting bracket (A).

Fig 3: Identifying Front Bumper Side Mounting Bracket
Courtesy of HYUNDAI MOTOR CO.
Using a screwdriver, remove the fender side cover (B).
After loosening the mounting bolts, then remove the fender (A).

Fig 4: Identifying Fender Side Cover And Fender
Courtesy of HYUNDAI MOTOR CO.
Installation is the reverse of removal