LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2011 >> Sorento Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Disc Brake System) >> Brake Pedal >> Repair procedures >> Removal

Repair procedures: Removal

WARNING: This page is about a different car, the 2011 Hyundai Tucson. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the crash pad lower panel. (Refer to the CRASH PAD .)
  2. Pull down steering column shaft after removing bolts and nuts.
  3. Disconnect the stop lamp switch connector (A).
    Fig 1: Identifying Stop Lamp Switch Connector
    G06874516Courtesy of HYUNDAI MOTOR CO.
  4. Remove the brake pedal member mounting nut (A).

    Tightening torque: 

    16.5 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 12.3 ~ 18.8 lb-ft)

    Fig 2: Identifying Brake Pedal Member Mounting Nut
    G06874517Courtesy of HYUNDAI MOTOR CO.
  5. Remove the snap pin (A) and clevis pin (B).
    Fig 3: Identifying Snap Pin And Clevis Pin
    G06874518Courtesy of HYUNDAI MOTOR CO.
  6. Remove the brake pedal member assembly mounting nuts and then remove the brake pedal assembly.

    Tightening torque: 

    16.7 ~ 25.5 N.m (1.7 ~2.6 kgf.m, 12.3 ~ 18.8 lb-ft)

    Fig 4: Identifying Brake Pedal Member Assembly Mounting Nuts
    G06874519Courtesy of HYUNDAI MOTOR CO.
scientia non olet · About LEMON Manuals