LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2011 >> Sorento Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Disc Brake System) >> Brake Booster >> Repair procedures >> Removal

Repair procedures: Removal

WARNING: This page is about a different car, the 2011 Hyundai Tucson. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch OFF and disconnect the negative (-) battery cable.
  2. Disconnect the battery positive terminal and then remove the battery.
  3. Disconnect the ECM connector and then ECM and battery tray.
  4. Disconnect the vacuum hose (A) from the brake booster.
    Fig 1: Identifying Vacuum Hose Of Brake Booster
    G06874502Courtesy of HYUNDAI MOTOR CO.
  5. Remove the master cylinder. (Refer to MASTER CYLINDER .)
  6. Remove the snap pin (A) and clevis pin (B).
    Fig 2: Identifying Snap Pin And Clevis Pin
    G06874503Courtesy of HYUNDAI MOTOR CO.
  7. Remove the mounting nuts.

    Tightening torque: 

    16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 12.3 ~ 18.8 lb-ft)

    Fig 3: Identifying Brake Booster Mounting Nuts
    G06874504Courtesy of HYUNDAI MOTOR CO.
  8. Remove the brake booster.
scientia non olet · About LEMON Manuals