Component Inspection

Check FTPS

Measure the output voltage with using the vacuum gauge.

CAUTION: Be careful while you do this procedure. FTPS would be damaged if you apply vacuum excessively.

Specification :

SPECIFICATION CHART

FTPS	Normal Parameter
Gauge pressure	-66.66 hpa (-139.2 lbf/ft² )	0 hpa	66.66 hpa (139.2 lbf/ft² )
Voltage	0.5 V	2.5 V	4.5 V

Fig 1: Measuring Output Voltage Between FTPS Connector Terminal And Ground

Courtesy of KIA MOTORS AMERICA, INC.

Is the measured voltage within specification?
YES
1. Substitute with a known-good PCM and check for proper operation. If the problem is corrected, replace PCM and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
1. Substitute with a known-good FTPS and check for proper operation. If the problem is corrected, replace FTPS and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.