LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2010 >> Soul Base >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Airbag Module >> Curtain Airbag (CAB) Module >> Repair procedures >> Installation

Repair procedures: Installation

  1. Remove the ignition key from the vehicle.
  2. Disconnect the battery negative cable and wait for at least three minutes.
  3. Tighten the Curtain Airbag (CAB) mounting bolts.

    Tightening torque 

    : 10.8 ~ 14.7 Nm (1.1 ~ 1.5 kgf.m, 8.0 ~ 10.8 lb.ft)

    CAUTION:
    • Never twist the airbag module when installing it. If the module is twisted, airbag module may operate abnormally.
  4. Connect the CAB connector.
  5. Install the headlining. (Refer to ROOF TRIM )
  6. Install the Interior trim. (Refer to INTERIOR TRIM )
  7. Reconnect the battery negative cable.
  8. After installing the Curtain Airbag (CAB), confirm proper system operation:
    1. Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
scientia non olet · About LEMON Manuals