LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2010 >> Sedona Base >> Repair and Diagnosis >> Restraints >> Restraints Control Systems >> Supplemental Restraints System Control Module (SRSCM) >> Seat Belt Buckle Switch (BS >> Repair procedures >> Installation

Repair procedures: Installation

CAUTION: Ensure that the harness is installed and routed properly to prevent damage to the wiring.
  1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
  2. Remove the ignition key from the vehicle.
  3. Install the seat belt buckle switch.

    Tightening Torque : 4.0 ~ 5.5 kgf.m (28.9 ~ 39.8 lb.ft)

  4. Install the seat recliner cover with two screws.
  5. Install the front seat assembly. (Refer to FRONT SEAT )
  6. Reconnect the battery negative cable.
  7. After installing the Seat Belt Buckle Switch, confirm proper system operation:

    Turn the ignition switch ON, the SRS indicator should be turned on for about six seconds and then go off.

scientia non olet · About LEMON Manuals