LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2010 >> Forte EX, Standard >> Repair and Diagnosis >> Restraints >> Restraints Control Systems >> SRSCM (Restraints - DEPOWERED) >> Side Impact Sensor (SIS) >> Repair procedures >> Installation

Repair procedures: Installation

CAUTION:
  • Do not turn the ignition switch ON and do not connect the battery cable while replacing the side impact sensor.
  1. Install the new side impact sensor with the bolt then connect the SRS harness connector to the side impact sensor.

    Tightening torque 

    : 6.8 ~ 7.9 Nm (0.7 ~ 0.8 kgf.m, 5.1 ~ 5.8 lb.ft)

  2. Install the center pillar trim. (For Coupe, refer to INTERIOR TRIM . For Sedan, refer to INTERIOR TRIM .)
  3. Install the door scuff trim. (For Coupe, refer to INTERIOR TRIM . For Sedan, refer to INTERIOR TRIM .)
  4. Reconnect the battery negative cable.
  5. After installing the side impact sensor, confirm proper system operation:
    1. Turn the ignition switch ON, the SRS indicator light should be turned on for about six seconds and then go off.
scientia non olet · About LEMON Manuals