Inspection Procedure

Refer to PREPARATION OF INSPECTION .

1. Measure resistance between the terminal 2 of SIS harness connector and the terminal 55 (53) of SRSCM harness connector.
2. Measure resistance between the terminal 1 of SIS harness connector and the terminal 54 (52) of SRSCM harness connector.

   Specification (resistance) : below 1 Ω

   Fig 1: Measuring Resistance Between SIS Harness Connector & SRSCM Harness Connector

   Courtesy of KIA MOTORS AMERICA, INC.
3. Is the measured resistance within specification?

   YES 

   • Check Side Impact Sensor.

   NO 

   • Repair or replace the wiring harness between the SIS and the SRSCM.

1. Replace the Side Impact Sensor (SIS) with a new one.
   • Refer to "SIDE IMPACT SENSOR (SIS)  " .
2. Install the DAB module and connect the DAB connector.
3. Connect the connectors of the PAB, KAB, CAB, BPT, FIS and SIS.
4. Connect the SRSCM connector.
5. Connect the battery negative cable to the battery.
6. Connect a Hi-Scan (Pro) to the data link connector.
7. Turn the ignition switch to ON and check the vehicle again.

   Does Hi-Scan (Pro) indicate any DTC related to Side Impact Sensor (SIS) ?

   YES 

   • Go to next step.

   NO 

   • Replace SIS.

Refer to CLEAR THE DTC AND CHECK THE VEHICLE AGAIN .