Control Circuit Inspection

Check short to ground in harness
1. IG "OFF" and disconnect OCV connector.
2. IG "ON" & ENG "OFF".
3. Measure resistance between terminal 2 of OCV harness connector and chassis ground.
  Specification: Infinite
  
  Fig 1: Measuring Resistance Between Terminal 2 Of OCV Harness Connector And Chassis Ground
  Courtesy of KIA MOTORS AMERICA, INC.
4. Is the measured resistance within specification?
  YES
  - Go to step 2.
  NO
  - Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
Check open in harness
1. IG "OFF" and disconnect OCV and ECM connector.
2. Measure resistance between terminal 2 of OCV harness connector and terminal 61 of ECM harness Connector (C144-B).
  Specification: Prix. below 1Ω
  
  Fig 2: Measuring Resistance Between Terminal 2 Of OCV Harness Connector And Terminal 61 Of ECM Harness Connector (C144-B)
  Courtesy of KIA MOTORS AMERICA, INC.
3. Is the measured resistance within specification?
  YES
  - Go to "COMPONENT INSPECTION " procedure.
  NO
  - Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.