Component Inspection

Check HO2S(B2/S1) Heater resistance

IG "OFF" and disconnect HO2S(B2/S1) connector

Measure resistance between terminal 1 and 2 of HO2S(B2/S1) (Component Side)

Specification:

RESISTANCE SPECIFICATION

Heater
Resistance (Ω)	8.1-11.1 Ω at 21°C (69.8°F)

Fig 1: Measuring Resistance Between Terminal 1 And 2 Of HO2S(B2/S1) (Component Side)

G06411308

Courtesy of KIA MOTORS AMERICA, INC.

Is the measured resistance within specification?
YES
- Substitute with a known-good ECM and check for proper operation. If the problem is corrected, replace ECM and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NOTE: There is a memory reset function on scan tool that can erase optional parts automatically detected and memorized by ECM.
Before or after testing ECM on the vehicle, use this function before reusing the ECM.

NO
- Substitute with a known-good HO2S(B2/S1) and check for proper operation. If the problem is corrected, replace HO2S (B2/S1) and go to "VERIFICATION OF VEHICLE REPAIR " procedure.