LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2009 >> Sorento Base, A5SR2 >> Repair and Diagnosis >> Engine Mechanical >> Cooling System (Mechanical) >> Repair Procedures >> Installation >> Water Temperature Control Assembly

Water Temperature Control Assembly

NOTE: Make clean the contact face before assembly.
  1. Install water temperature control assembly (A) and new gasket.

    Tightening torque 

    19.6 ~ 23.52 Nm (2.0 ~ 2.4 kgf.m, 14.5 ~ 17.36 lb-ft)

    Fig 1: Identifying Water Temperature Control Assembly
    G06407824Courtesy of KIA MOTORS AMERICA, INC.
    NOTE: Use new O-rings (C) when reassembling.
  2. Connect water hoses to the water temperature control assembly.
  3. Install the fuel pipe (A).
    Fig 2: Identifying Fuel Pipe
    G06407825Courtesy of KIA MOTORS AMERICA, INC.
  4. Connect WTS connector.
  5. Connect the RH/LH cooling pipes (A, B).
    Fig 3: Identifying RH/LH Cooling Pipes (1 Of 2)
    G06407826Courtesy of KIA MOTORS AMERICA, INC.
    Fig 4: Identifying RH/LH Cooling Pipes (2 Of 2)
    G06407827Courtesy of KIA MOTORS AMERICA, INC.
  6. Install the battery assembly (A).
    Fig 5: Identifying Battery Assembly
    G06407828Courtesy of KIA MOTORS AMERICA, INC.
  7. Install the automatic transaxle oil gauge.
  8. Install air cleaner assembly.
  9. Fill with engine coolant.
  10. Start engine and check for leaks.
  11. Recheck engine coolant level.
scientia non olet · About LEMON Manuals