LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2009 >> Sedona Base >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Power Tailgate System >> PTG Power Latch >> Replacement

PTG Power Latch: Replacement

  1. Disconnect the negative (-) battery terminal.
  2. Remove the tailgate trim. Refer to TAILGATE .
  3. Remove the tailgate handle rod, actuator rod and key rod.
  4. Remove the unlatch actuator assembly (A) after removing the connector and nuts (3EA).
    Fig 1: Identifying Unlatch Actuator Assembly
    G04885038Courtesy of KIA MOTORS AMERICA, INC.
  5. Remove the tailgate handle rod (A) and connector (B) from the cinching latch assembly (C).
    Fig 2: Identifying Tailgate Handle Rod And Connector
    G04885039Courtesy of KIA MOTORS AMERICA, INC.
  6. Remove the latch mounting screws (3EA) and cinching latch assembly (A) from the tailgate.
    Fig 3: Identifying Cinching Latch Assembly And Latch Mounting Screws
    G04885040Courtesy of KIA MOTORS AMERICA, INC.
  7. Installation is the reverse of removal.
    NOTE:
    • Check the power tailgate for normal operation.
    • Check the normal operating whenever a power tailgate component is removed or replaced. If the chime sound is heard, check the DTC, wiring harness and cable connections.
scientia non olet · About LEMON Manuals