LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2009 >> Sedona Base >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> DTC Troubleshooting Procedures (2 Of 2) >> P2197: Ho2S Signal Stuck Lean (Bank 2/Sensor 1) >> Monitor Scan Tool Data

Monitor Scan Tool Data

  1. Connect scan tool to DLC (Data Link Connector)
  2. Warm up the engine to normal operating temperature.
  3. Monitor "HO2S (B2S1)" parameter on scan tool

    Specification: 0.1-0.9V

    Fig 1: Scan Tool Display Screen - Oxygen Sensor
    G04883619Courtesy of KIA MOTORS AMERICA, INC.
  4. Does the "HO2S (B2S1)" parameter operates correctly?

    YES 

    • Fault is intermittent caused by poor contact in Sensor's and/or PCM's connector or was repaired and PCM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure

    NO 

scientia non olet · About LEMON Manuals