LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2009 >> Sedona Base >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> DTC Troubleshooting Procedures (2 Of 2) >> P0660: Intake Manifold Tuning Valve Control Circuit/Open (Bank 1) >> Monitor Scan Tool Data

Monitor Scan Tool Data

  1. IG "OFF" & connect scan tool.
  2. ENG "ON" and warm -up the engine to normal operating temperature.
  3. Monitor "VIS 1" item on the service data.
    Fig 1: Scan Tool Display Screen - VIS 1 Operation
    G04883543Courtesy of KIA MOTORS AMERICA, INC.
  4. Is the related current data displayed correctly?

    YES 

    • Fault is intermittent caused by poor contact in Sensor' s and/or PCM' s connector or was repaired and PCM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure

    NO 

scientia non olet · About LEMON Manuals