Component Inspection

Check wind shield defogger
1. Connect scan tool to Data Link Connector (DLC).
2. Ignition "ON" & engine "OFF".
3. Check if DTC is erased after replacing defogger with "defogger for test".
4. Is the DTC erased?
  YES
  
  Replace "defogger for test" with "new defogger" and go to "VERIFICATION OF VEHICLE REPAIR ".
  
  NO
  
  Go to step 2.
Check FAM
1. Connect scan tool to Data Link Connector (DLC).
2. Ignition "ON" & engine "OFF".
3. Check if DTC is erased after replacing FAM with "FAM for test".
4. Is the DTC erased?
  YES
  
  Replace "FAM for test" with "new FAM" and go to "VERIFICATION OF VEHICLE REPAIR ".
  
  NO
  
  Check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
  
  Repair or replace if necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.