LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2009 >> Sedona Base >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> BCM (Body Control Module) >> Body Network System >> DTC Codes >> DTC B1628: Module Configuration Conflict >> Monitor DTC Status

Monitor DTC Status

  1. Connect scan tool to Data Link Connector (DLC).
  2. Ignition "ON" & engine "OFF".
  3. Select "Diagnostic Trouble Codes (DTC s)" mode and monitor "DTC Status" parameter.
  4. Is the DTC B1628 present?

    YES 

    Go to COMPONENT INSPECTION  procedure.

    NO 

    Fault is intermittent caused by poor contact in the sensor's and/or ECM's connector or was repaired and ECM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

scientia non olet · About LEMON Manuals