LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2009 >> Rondo EX, 2.4 8 >> Repair and Diagnosis >> Restraints >> Restraints Control Systems >> SRS Control Module >> Seat Belt Buckle Switch (BS) >> Repair Procedure >> Installation

Repair Procedure: Installation

CAUTION: Be sure to install the harness wires not to be pinched or interfered with other parts.
  1. Remove the ignition key from the vehicle.
  2. Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
  3. Install the seat belt buckle switch.

    Tightening Torque: 4.0 ~ 5.5 kgf.m (28.9 ~ 39.8 lb.ft)

  4. Install the front seat assembly. (Refer to FRONT SEAT )
  5. Reconnect the battery negative cable.
  6. After installing the Seat Belt Buckle Switch, confirm proper system operation:

    Turn the ignition switch ON, the SRS indicator should be turned on for about six seconds and then go off.

scientia non olet · About LEMON Manuals