LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2009 >> Rio Base, Standard >> Repair and Diagnosis >> Engine Performance >> System >> DTC Troubleshooting Procedures (1 Of 2) >> DTC P0335 Crankshaft Position Sensor A Circuit >> Monitor Scan Tool Data

Monitor Scan Tool Data

  1. Connect scan tool to DLC (Data Link Cable).
  2. Engine start.
  3. Monitor the "CKP" parameters on the scan tool.
    Fig 1: Monitoring CKP Parameter On Scan Tool
    G04862214Courtesy of KIA MOTORS AMERICA, INC.
  4. Are the parameters displayed correctly?

    YES 

    • Fault is intermittent caused by poor contact in the sensor's and/or ECM/PCM's connector or was repaired and ECM/PCM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

scientia non olet · About LEMON Manuals