Front Driveshaft Assembly: Installation

Apply gear oil on the driveshaft splines (A) and the contacting surface of differential case oil seal (B).
Before installing the driveshaft (C), set the opening side of the clip (D) facing downward.

Fig 1: Applying Gear Oil On Driveshaft Splines
Courtesy of KIA MOTORS AMERICA, INC.
After installation, check that the driveshaft cannot be removed by hand.
Install the driveshaft into the knuckle.
CAUTION: Be careful not to damage the boot.
Install the lower arm assembly bolts (A) to the knuckle.
Tightening torque N.m (kgf.m, lb-ft) :

100-120 (10-12, 72-86)

Fig 2: Identifying Lower Arm Mounting Bolts
Courtesy of KIA MOTORS AMERICA, INC.
Install the tie rod end (A) to the knuckle (B).
Tightening torque N.m (kgf.m, lb-ft) :

16-34 (1.6-3.4, 12-25)

Fig 3: Identifying Tie Rod And Knuckle
Courtesy of KIA MOTORS AMERICA, INC.
Install the wheel speed sensor (A) to the knuckle (B).

Fig 4: Identifying Wheel Speed Sensor To Knuckle
Courtesy of KIA MOTORS AMERICA, INC.
After installing the washer (B) with convex surface outward, install the lock nut (A) and the split pin (C).

Fig 5: Identifying Lock Nut And Split Pin
Courtesy of KIA MOTORS AMERICA, INC.
Install the wheel and tire.