Component Inspection

■ Check Mode Switch 

1. IG KEY OFF.
2. Disconnect Mode switch connector.
3. Measure resistance between one and the other terminal of mode switch connector.

Specification : 

4. Is the measured value within specification?

   YES 

   • Check TCCM connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

   NO 

   • Substitute with a known good Mode Switch and check for proper operation.

     If the problem is corrected, replace Mode Switch and then go to "VERIFICATION OF VEHICLE REPAIR " procedure