Neutralization Status Check
- Connect the cable of scan tool to the data link connector in driver side crash pad lower panel.
- After IG ON, select the "Neutralization mode".
Input Switch List
INPUT SWITCH LIST
| No | Item name | Unit |
|---|---|---|
| 1 | SSB SW2 | - |
| 2 | ACC | - |
| 3 | IGN1 | - |
| 4 | Gear 'P' Position | - |
| 5 | Brake SW | - |
| 6 | FL Door Lock Button | - |
| 7 | FR Door Lock Button | - |
| 8 | Tailgate SW | - |
| 9 | Battery Voltage | - |
| 10 | Alternator Voltage | - |
| 11 | Immobilizer Lamp | - |
| 12 | External Buzzer | - |
| 13 | ESCL Enable | - |
| 14 | SMK 'Power Mode' State | - |
Actuator List
ACTUATOR LIST
| No. | Item name | Condition |
|---|---|---|
| 1 | Immo. indicator Lamp | Ignition switch ON Engine off |
| 2 | External Buzzer | Ignition switch ON Engine off |
| 3 | Interior Antenna 1 Active | Ignition switch ON Engine off |
| 4 | Interior Antenna 2 Active | Ignition switch ON Engine off |
| 5 | Interior Antenna 3 Active | Ignition switch ON Engine off |
| 6 | Trunk Antenna Active | Ignition switch ON Engine off |
| 7 | Bumper/tail Gate Antenna Active | Ignition switch ON Engine off |
| 8 | DRV_DR Antenna Active | Ignition switch ON Engine off |
| 9 | AST_DR Antenna Active | Ignition switch ON Engine off |