Air Bag Module And CLOCKSPRING: Installation
- Disconnect the negative (-) cable from battery and wait for at least three minutes.
- Remove ignition key from the vehicle.
- Connect the Driver Airbag (DAB) harness connectors, then install a Driver Airbag (DAB) module on the steering wheel.
- Secure the Driver Airbag (DAB) with the new mounting bolts.
Tightening Torque (DAB Mounting Bolt) : 7.8 ~ 10.8 N.m (5.8 ~ 8.0 lb. ft.)
- Connect the battery negative cable.
- After installing the airbag, confirm proper system operation:
- Turn the ignition switch ON; the SRS indicator light should blink for about six times and then go off.
- Make sure both horn buttons work.