LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2008 >> Spectra5 2.0 2, Standard >> Repair and Diagnosis >> Engine Performance >> System >> DTC Troubleshooting Procedures >> Inspection Chart For Diagnostic Trouble Codes (DTC) >> DTC P0077 Intake Valve Control Solenoid Circuit High (Bank 1) >> Component Inspection

Component Inspection

  1. Ignition "OFF"
  2. Disconnect oil control valve connector
  3. Measure resistance between terminals 1 and 2 of the solenoid connector (Component side).

    SPECIFICATION 

    RESISTANCE SPECIFICATIONS

    Temp. (°C) Temp. (°F) Resistance (Ω)
    0 32 6.2-7.4
    10 50 6.5-7.7
    20 68 6.9-7.9
    30 86 7.1-8.3
    40 104 7.4-8.6
    50 122 7.7-8.9
    60 140 8.0-9.2
    70 158 8.3-9.5
    80 176 8.6-9.8
    90 194 8.9-10.1
    100 212 9.2-10.4
    Fig 1: Measuring Resistance Between Terminals 1 And 2 Of Solenoid Connector
    G05115435Courtesy of KIA MOTORS AMERICA, INC.
  4. Is resistance within specification?

    YES 

    • Perform wiring harness inspection procedure and repair as necessary.

    NO 

    • Check oil control valve for contamination, deterioration, or damage. Substitute with a known-good solenoid and check for proper operation. If the problem is corrected, replace solenoid and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
scientia non olet · About LEMON Manuals