Fundamental Procedures: Reassembly

Standard values, such as torques and certain adjustments, must be strictly observed in the reassembly of all parts. If removed, the following parts should be replaced with new ones:

1. Oil seals
2. O-rings
3. Cotter pins
4. Gaskets
5. Lock washers
6. Nylon nuts
   Fig 1: Torquing Fastener

   Courtesy of KIA MOTORS AMERICA, INC.

DEPENDING ON LOCATION: 

1. Sealant should be applied or new gaskets installed.
2. Oil should be applied to the moving components of parts.
3. Specified oil or grease should be applied at the appropriate locations (such as oil seals) before reassembly.
   Fig 2: Applying Sealant

   Courtesy of KIA MOTORS AMERICA, INC.