Oil Pump

1. Place the inner and outer rotors into front case with the marks facing the oil pump cover side.
2. Install the oil pump cover (A) to front case with the 7 screws (B).

   Tightening torque: 5.9-8.8 N.m (0.6-0.9 kg-m, 4.3-6.5 lb-ft)

   Fig 1: Installing Oil Pump Cover

   Courtesy of KIA MOTORS AMERICA, INC.

1. Place a new front case gasket on the cylinder block.
2. Apply engine oil to the lip of the oil pump seal. Then, install the oil pump onto the crankshaft.
3. When the pump is in place, clean any excess grease off the crankshaft and check that the oil seal lip is not distorted.
   Fig 2: Identifying Oil Pump Bolts

   Courtesy of KIA MOTORS AMERICA, INC.

   Bolt length:

   (A): 25 mm (0.984 in), (B): 30 mm (1.181 in), (C): 38 mm (1.496 in), (D): 45 mm (1.772 in)

   Tightening torque: 19.6-26.5 N.m (2.0-2.7 kg-m, 14.5-19.5 lb-ft)

Tightening torque: 14.7-21.6 N.m (1.5-2.2 kg-m, 10.8-15.9 lb-ft)

Tightening torque: 9.8-11.8 N.m (1.0-1.2 kg-m, 7.2-8.7 lb-ft)

Tightening torque: 42.2-53.9 N.m (4.3-5.5 kg-m, 31.1-39.8 lb-ft)