Signal Circuit Inspection
WARNING: This page is about a different variant/trim than selected.
- Ignition "ON" & Engine "OFF".
- Disconnect the "C106-3" connector.
- Measure voltage between terminal "6" of the C106-3 harness connector and chassis ground.
Specification : Approx. 5 V
- Is voltage within specifications?
YES
- Go to "POWER SUPPLY CIRCUIT INSPECTION " procedure.
NO
- Check for open or short in harness. Repair as necessary and Go to "VERIFICATION OF VEHICLE REPAIR " procedure. If signal circuit in harness is OK, Go to "CHECK TCM " of the "COMPONENT INSPECTION " procedure.