LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2008 >> Rondo LX, 2.7 4 >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Gasoline Engine Control System (G6EA - GSL 2.7L) >> Accelerator Position Sensor (APS) >> Inspection >> Component Inspection

Component Inspection

  1. Connect a scan tool to the Diagnosis Link Connector (DLC).
  2. Start engine and check output voltages of APS 1 and 2 at C.T and W.O.T.

    SPECIFICATION 

    VOLTAGE OUTPUT SPECIFICATION

    Condition Output Voltage (V)
    APS1 APS2
    C.T 0.70 ~ 0.80 0.29 ~ 0.46
    W.O.T 3.85 ~ 4.35 1.93 ~ 2.18
  3. Turn ignition switch OFF and disconnect the scan tool from the DLC.
  4. Disconnect APS connector and measure resistance between APS terminals 4 and 5 (APS 1).

    Specification: Refer to SPECIFICATION .

  5. Disconnect APS connector and measure resistance between APS terminals 1 and 6 (APS 2).
    Fig 1: Measuring Resistance Between APS Terminals 4 And 5 (APS 1)
    G04804514Courtesy of KIA MOTORS AMERICA, INC.

    Specification: Refer to SPECIFICATION .

scientia non olet · About LEMON Manuals