LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2008 >> Rio Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Abs (Anti-Lock Brake System)) >> Diagnostic Trouble Code Chart(DTC) >> DTC C2402 Motor-Electrical >> DTC Detecting Condition

DTC C2402 Motor-Electrical: DTC Detecting Condition

WARNING: This page is about a different car, the 2007 Kia Sedona and 2006 Kia Sedona. However, it is still accessible from the selected car via links, so may be relevant.
DTC DETECTING CONDITION CHART

Item Detecting Condition Possible cause
DTC strategy
  • Voltage monitoring
  • Open or short of power supply circuit (ABS1)
  • Inoperative HECU
Case1 (Stop monitor) Monitoring Period
  • Stop monitor is active if the pump is off i.e. not actuation and no Slowdown.
Enable Conditions
  • A failure is detected if the pump motor voltage > 2.0 V for more than 1 s.
Fail Safe
  • The return pump does not work correct.
  • The ABS/ESC functions are inhibited, reduced function of the EBD system.
  • The ABS/EBD/ESC warning lamps are activated.
Case2 (Pump run monitor) Monitoring Period
  • The monitor is active if the pump is switched on
Enable Conditions
  • A failure is detected if the pump motor voltage < (battery voltage - 4.0 V) for more than 100ms.
Fail Safe
  • Pressure decrease (outlet valve) is no longer possible.
  • The ABS/ESC functions are inhibited, reduced function of the EBD system.
  • The ABS/EBD/ESC warning lamps are activated.
Case3 (Pump slowdown monitor) Monitoring Period
  • Monitor is always active in the transition "pump on → pump off"
Enable Conditions
  • After the end of the actuation of the motor relay has, the pump motor is still in motion and is generating a Voltage during it.s slowdown. The generated UM is monitored for a certain time on high level. The time depends on the supply voltage and is in the range of t = 30 ms to t = 125 ms. If the slow down condition isn't met, the pump is activated again (see actuation times below) and the slowdown time is measured again. This is repeated for maximum n = 3 times. If, after the last pump activation, the pump motor slowdown time is still to short, a failure is detected. Actuation times:

    1st actuation: 200 ms

    2nd actuation: 1000 ms

    3rd actuation: 3000 ms
Fail Safe
  • Pressure decrease (outlet valve) is no longer possible.
  • The ABS/ESC functions are inhibited, reduced function of the EBD system.
  • The ABS/EBD/ESC warning lamps are activated.
scientia non olet · About LEMON Manuals