LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2008 >> Rio Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (SRS Control System) >> Seat Belt Buckle Switch >> Installation

Seat Belt Buckle Switch: Installation

WARNING: This page is about a different car, the 2008 Kia Optima and 2008 Kia Magentis. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Ensure that the harness is installed and routed properly to prevent damage to the wiring.
  1. Disconnect the battery negative cable, and wait for at least 3 minutes before beginning work.
  2. Remove the ignition key from the vehicle.
  3. Install the seat belt buckle switch.

    Tightening Torque: 4.0-5.5 kgf.m (28.9-39.8 lb.ft)

  4. Install the seat recliner cover with two screws.
  5. Install the front seat assembly. Refer to SEAT .
  6. Reconnect the battery negative cable.
  7. After installing the Seat Belt Buckle Switch, confirm proper system operation:

    Turn the ignition switch ON, the SRS indicator should be turned on for about 6 seconds and then go off.

scientia non olet · About LEMON Manuals