Component Replacement After Deployment
WARNING: This page is about a different car, the 2008 Kia Optima and 2008 Kia Magentis. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Before doing any SRS repairs, use the Hi-Scan Pro to check for DTCs. Refer to DIAGNOSTIC TROUBLE CODES (DTC)
for repairing of the related DTCs.
When the front airbag(s) deployed after a collision, replace the following items.
- SRSCM
- Deployed airbag(s)
- Seat belt pretensioner(s)
- Front impact sensors
- SRS wiring harnesses
- Inspect the clock spring for heat damage.
If any damage found, replace the clock spring.
When the seat belt pretensioner(s) deployed after a collision, replace the following items.
- Seat belt pretensioner(s)
- SRSCM (if B1658 detected)
- Front impact sensors
- SRS wiring harnesses
When the side/curtain airbag(s) deployed after a collision, replace the following items.
- SRSCM
- Deployed airbag(s)
- Side impact sensor(s) for the deployed side(s)
- SRS wiring harnesses
After the vehicle is completely repaired, confirm the SRS airbag system is OK.
- Turn the ignition switch ON, the SRS indicator should come on for about 6 seconds and then go off.