LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2008 >> Rio Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Brake System) >> Master Cylinder >> Disassembly

Master Cylinder: Disassembly

WARNING: This page is about a different car, the 2007 Kia Sedona and 2006 Kia Sedona. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the reservoir cap and drain the brake fluid into a suitable container.
  2. Remove the fluid level sensor.
  3. Remove the reservoir from the master cylinder, after remove mounting screw (A).
    Fig 1: Identifying Reservoir Mounting Screw
    G04882837Courtesy of KIA MOTORS AMERICA, INC.
  4. Remove the retainer ring (A) by using the snap ring pliers then remove the primary piston assembly.
    Fig 2: Identifying Retainer Ring
    G04882838Courtesy of KIA MOTORS AMERICA, INC.
  5. Remove the primary piston assembly (A).
  6. Remove the pin (C) with the secondary piston (B) pushed completely using a screwdriver. Remove the secondary piston assembly (B).
    Fig 3: Identifying Primary Piston, Secondary Piston And Pin
    G04805858Courtesy of KIA MOTORS AMERICA, INC.
    NOTE: Do not disassemble the primary and secondary piston assembly.
scientia non olet · About LEMON Manuals