LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2008 >> Magentis 2.4 3 >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Transaxle System (A/T) >> DTC P0885 A/T Relay Circuit Malfunction >> Monitor Scan Tool Data

Monitor Scan Tool Data

  1. Connect scan tool to data link connector (DLC).
  2. Ignition "ON" & Engine "OFF".
  3. Monitor the "A/T CON. RELAY VOLT" parameter on the scan tool.

    Specification: Approx. B+

    Fig 1: Display Screen Of - A/T Con. Relay Volt
    G04805192Courtesy of KIA MOTORS AMERICA, INC.
  4. Is A/T RELAY VOLT within specifications?

    YES  : --> Fault is intermittent caused by poor contact in the sensor's and/or TCM (PCM)'s connector or was repaired and TCM (PCM) memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration or damage. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO  : --> Go to "TERMINAL & CONNECTOR INSPECTION " procedure.

scientia non olet · About LEMON Manuals