Monitor SCANTOOL Data

WARNING: This page is about a different car, the 2007 Kia Optima, 2007 Kia Magentis, 2006 Kia Optima, and 2006 Kia Magentis. However, it is still accessible from the selected car via links, so may be relevant.

Connect scantool to data link connector (DLC).
Ignition "ON" & Engine "OFF".
Monitor the "A/T CON. RELAY VOLT" parameter on the scantool.
Specification: Approx. B+

Fig 1: Display Screen Of - A/T Con. Relay Volt
Courtesy of KIA MOTORS AMERICA, INC.
Is A/T RELAY VOLT within specifications?
YES : --> Fault is intermittent caused by poor contact in the sensor's and/or TCM (PCM)'s connector or was repaired and TCM (PCM) memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration or damage. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

NO : --> Go to "TERMINAL & CONNECTOR INSPECTION " procedure.