Clutch Master Cylinder: Installation

Connect the clutch tube (A) (release cylinder side).

Fig 1: Connecting Clutch Hose At Release Cylinder
Courtesy of KIA MOTORS AMERICA, INC.
Temporarily tighten the flare nut by hand, then tighten it to the specified torque, being careful that the clutch hose does not become twisted.

Fig 2: Tightening Flare Nut Fitting
Courtesy of KIA MOTORS AMERICA, INC.
Install the clutch tube and clips (A).

Fig 3: Installing Clutch Tube & Clips
Courtesy of KIA MOTORS AMERICA, INC.
Install the master cylinder (A).

Fig 4: Installing Master Cylinder
Courtesy of KIA MOTORS AMERICA, INC.
Apply the specified grease to the clevis pin and washer.
Wheel bearing grease: SAE J310, NLGI NO. 2

Fig 5: Identifying Clevis Pin
Courtesy of KIA MOTORS AMERICA, INC.
Install the push rod to the clutch pedal.
Pour the clutch fluid into the clutch master cylinder.
Bleed the clutch system.