Signal Circuit Inspection

1. Ignition "OFF".
2. Disconnect PCM connector.
3. Measure resistance between terminals 3 of sensor harness connector and 10 of the PCM harness connector.

   Specification : Approx. 0Ω

4. Is resistance within the specification?

   YES 

   • Go to next step as below

   NO 

   • Check for an open in signal harness. Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

1. Measure resistance between terminal 3 of sensor harness connector and chassis ground.

   Specification : Infinite

2. Is resistance within the specification?

YES 

• Go to "COMPONENT INSPECTION " procedure,

NO 

• Check for short to ground in signal harness. Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.