LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2007 >> Sorento Base, A5SR2 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Restraints (Except Troubleshooting)) >> SRS Control System >> Side Impact Sensor (Sis) >> Installation

Side Impact Sensor (Sis): Installation

WARNING: This page is about a different variant/trim than selected.
CAUTION:
  • Do not turn the ignition switch ON and do not connect the battery cable while replacing the side impact sensor.
  1. Install the new Side Impact Sensor with the bolt then connect the SRS harness connector to the Side Impact Sensor.

    Tightening torque: 1.0-1.4 kgf.m (10.2-13.8 N.m, 7.5-10.2 lb.ft)

  2. Install the center pillar trim. Refer to BODY (INTERIOR AND EXTERIOR) .
  3. Install the door scuff trim. Refer to BODY (INTERIOR AND EXTERIOR) .
  4. Install the lower anchor bolt.
  5. Reconnect the battery negative cable.
  6. After installing the Side Impact Sensor, confirm proper system operation: Turn the ignition switch ON, the SRS indicator light should be turned on for about six seconds and then go off.
scientia non olet · About LEMON Manuals