Component Inspection

1. Ignition "OFF"
2. Measure resistance between terminals "1" and "2" of the CCV connector.

   Specification: Approx. 19.8 ~21.8Ω (20°C (68°F))

   Fig 1: Measuring Resistance Between Terminals 1 And 2 Of CCV Connector

   Courtesy of KIA MOTORS AMERICA, INC.
3. Monitor the CCV signal waveform and verify that the ground voltage is less than approx. 0.3V ([1]) and the surge voltage ([2]) is between 40 V and 60 V.
   NOTE: [1] and [2] refer to points in Fig 2.
   Fig 2: CCV Signal Waveform

   Courtesy of KIA MOTORS AMERICA, INC.
4. Is the CCV normal?

YES 

• Substitute with a known - good PCM and check for proper operation.
• If the problem is corrected, replace PCM and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

NO 

• Substitute with a known - good CCV and check for proper operation.
• If the problem is corrected, replace CCV and go to "VERIFICATION OF VEHICLE REPAIR " procedure.