LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2007 >> Sedona Base >> Repair and Diagnosis >> Engine Performance >> System >> DTC Troubleshooting Procedures (1 Of 2) >> DTC P0335 Crankshaft Position Sensor A Circuit >> Monitor SCANTOOL Data

Monitor SCANTOOL Data

  1. IG "OFF" & connect scantool.
  2. ENG "ON" and warm -up the engine to normal operating temperature.
  3. Monitor engine speed item on the service data.

    Specification: 650 ± 100 RPM

    Fig 1: Scan Tool Display Screen - Engine Speed
    G04883437Courtesy of KIA MOTORS AMERICA, INC.
  4. Is the service data displayed correctly?

    YES 

    • Fault is intermittent caused by poor contact in the sensor' s and/or PCM' s connector or was repaired and PCM memory was not cleared. Thoroughly check connectors for looseness, poor connection, ending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure

    NO 

scientia non olet · About LEMON Manuals