Component Inspection

Check assist door lamp
1. Connect scantool to Data Link Connector (DLC).
2. Ignition "ON" & engine "OFF"
3. Select `ACTUATION TEST' mode on scantool and press [F1] to start
  
  Fig 1: Identifying Scantool Display - Actuation Test Of Assist Door Lamp
  Courtesy of KIA MOTORS AMERICA, INC.
4. Dose assist door lamp work properly?
  YES
  
  Go to 2 "Check ADM" procedure.
  
  NO
  
  Substitute with a known-good assist door lamp and check for proper operation.
  
  If the problem is corrected, replace assist door lamp and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
Check ADM
1. Connect scantool to Data Link Connector (DLC).
2. Ignition "ON" & engine "OFF"
3. Substitute with a known-good ADM and Check if the DTC is erased.
4. Is the DTC erased?
  YES
  
  Substitute with a known-good ADM and check for proper operation.
  
  If the problem is corrected, replace ADM and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
  
  NO
  
  Check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
  
  Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.