LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2007 >> Sedona Base >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> DTC Troubleshooting Procedures (1 Of 2) >> DTC P0325 Knock Sensor 1 Circuit; DTC P0330 Knock Sensor 2 Circuit >> Monitor SCANTOOL Data

Monitor SCANTOOL Data

  1. IG "OFF" & connect scantool.
  2. ENG "ON" and warm -up the engine to normal operating temperature.
  3. Monitor item related to knock sensor on the service data.
    Fig 1: Scan Tool Display Screen - Knock Sensor Application Cylinder1
    G04883433Courtesy of KIA MOTORS AMERICA, INC.
  4. Is the service data displayed correctly?

    YES 

    • Fault is intermittent caused by poor contact in the sensor' s and/or PCM' s connector or was repaired and PCM memory was not cleared. Thoroughly check connectors for looseness, poor connection, ending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure

    NO 

scientia non olet · About LEMON Manuals