LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2007 >> Sedona Base >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> DTC Troubleshooting Procedures (1 Of 2) >> DTC P0110 Intake Air Temperature Sensor 1 Circuit >> Monitor SCANTOOL Data

Monitor SCANTOOL Data

  1. IG "OFF" & connect scantool.
  2. ENG "ON" and warm -up the engine to normal operating temperature.
  3. Monitor "IATS" item on the service data.
    Fig 1: Scantool Display - Current Data
    G04883324Courtesy of KIA MOTORS AMERICA, INC.
  4. Is the "IATS" data displayed correctly?

    YES 

    • Fault is intermittent caused by poor contact in the sensor' s and/or PCM' s connector or was repaired and PCM memory was not cleared. Thoroughly check connectors for looseness, poor connection, ending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure

    NO 

scientia non olet · About LEMON Manuals