LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2007 >> Sedona Base >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> DTC Troubleshooting Procedures (1 Of 2) >> DTC P0026 Intake Valve Control Solenoid; Circuit Range/Performance (Bank 1); DTC P0028 Intake Valve Control Solenoid Circuit Range/Performance (Bank 2) >> Monitor SCANTOOL Data

Monitor SCANTOOL Data

  1. IG "OFF" & connect scantool.
  2. ENG "ON" and warm -up the engine to normal operating temperature.
  3. Monitor "CAM (B1/B2)" status on the service data.

    [P0026] 

    Fig 1: Scantool Display - Current Data (P0026)
    G04883267Courtesy of KIA MOTORS AMERICA, INC.

    [P0028] 

    Fig 2: Scantool Display - Current Data (P0028)
    G04883268Courtesy of KIA MOTORS AMERICA, INC.
  4. Are the "CMP (B1/B2)" data displayed correctly ?

    YES 

    • Fault is intermittent caused by poor contact in the sensor' s and/or PCM' s connector or was repaired and PCM memory was not cleared. Thoroughly check connectors for looseness, poor connection, ending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure

    NO 

scientia non olet · About LEMON Manuals