LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2007 >> Sedona Base >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> BCM (Body Control Module) >> Body Network System >> DTC Codes >> DTC B1613 Lost Communication With CLU, Bus Failure >> Component Inspection

Component Inspection

  1. Check Cluster module
    1. Connect scantool to Data Link Connector (DLC).
    2. Ignition "ON" & engine "OFF".
    3. Substitute with a known-good Cluster module and Check if the DTC is erased.
    4. Is the DTC erased?

      YES 

      Substitute with a known-good Cluster module and check for proper operation.

      If the problem is corrected, replace Cluster module and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

      NO 

      Go to  2 "Check IPM" procedure.

  2. Check IPM
    1. Connect scantool to Data Link Connector (DLC).
    2. Ignition "ON" & engine "OFF".
    3. Substitute with a known-good IPM and Check if the DTC is erased.
    4. Is the DTC erased?

      YES 

      Substitute with a known-good IPM and check for proper operation.

      If the problem is corrected, replace IPM and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

      NO 

      Check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.

      Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

scientia non olet · About LEMON Manuals