LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2007 >> Rondo Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Automatic Transaxle Control System (A5GF1)) >> Output Speed Sensor >> Installation

Output Speed Sensor: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install the new O-ring to the output shaft speed sensor.
  2. Install the output shaft speed sensor.

    TORQUE:

    10-12 N.m (1.0-1.2 kgf.m, 7-8 lb-ft)

    CAUTION: While installing the output shaft speed sensor, do not allow dust or other foreign particles to enter the transaxle.
  3. Check the connector for dust, dirt, or oil, then connect the connector securely.
  4. Installation is the reverse of removal.
scientia non olet · About LEMON Manuals