Component Inspection

Set up an oscilloscope as follows :
Channel A (+): terminal 3 of the CKPS (back probe), (-): ground

Channel B (+): terminal 3 of the CMPS (back probe), (-): ground
Start the engine and check for signal waveform compared with reference waveform as below.

Fig 1: Identifying Signal Waveform
Is the signal waveform normal?
YES
- Go to TERMINAL AND CONNECTOR INSPECTION
NO
- Remove CKP and calculate air gap between sensor and flywheel/torque converter. Readjust as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure

NOTE: Air gap [0.3~1.7 mm [0.012~0.067 in] = measure distance from housing to teeth on flywheel/torque converter (measurement "A") and from mounting surface on sensor to sensor tip (measurement "B") subtract "B" from "A"

If fail to synchronize with CMP sensor, check that the crankshaft and camshaft are correctly aligned the matching marks of the pulleys. Repair or readjust as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure
Check CKPS for contamination, deterioration, or damage. Substitute with a known-good CKPS and check for proper operation. If the problem is corrected, replace CKPS and then go to "VERIFICATION OF VEHICLE REPAIR " procedure