LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2007 >> Rondo Base >> Repair and Diagnosis (Single Page) >> Transmission >> Automatic Trans >> Automatic Transaxle System (F4A42) >> Automatic Transaxle System >> DTC P0708 Transaxle Range Switch - High Input >> DTC Detecting Condition

DTC P0708 Transaxle Range Switch - High Input: DTC Detecting Condition

DTC DETECTING CONDITION

Item Detecting Condition Possible cause
DTC Strategy 
  • Check for multiple signals
  • Open or short in circuit
  • Faulty Shift cable adjustment
  • Faulty Inhibitor switch and Manual control lever position adjustment
  • Faulty TRANSAXLE RANGE SWITCH
  • Faulty PCM
Enable Conditions
  • Always
Threshold value 
  • Multiple signal
Diagnostic Time 
  • more than 30sec
Fail Safe 
  • Recognition as previous signal
    • When signal is input "D" and "N" at the same time, TCM regards it as "N" RANGE
    • After PCM/TCM Reset, If the if the PCM/TCM detects multiple signal or no signal, then it holds the 3rd gear position