LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2007 >> Rondo Base >> Repair and Diagnosis (Single Page) >> Restraints >> Air Bag, SRS >> Restraints (Except Troubleshooting) >> Supplemental Restraint System Control Module (SRSCM) >> SRS Control Module >> Installation

SRS Control Module: Installation

  1. Remove the ignition key from the vehicle.
  2. Disconnect the battery negative cable and wait for at least three minutes before beginning work.
  3. Install the SRSCM with the SRSCM mounting nuts.

    Tightening torque (SRSCM Mounting bolt) : 0.7-0.9 kgf.m (7.0-9.0 N.m, 5.2-6.6 lb. ft.)

    NOTE: Use new mounting bolts when replacing the SRSCM after a collision.
  4. Connect the SRSCM harness connector.
  5. Install the heater ducts and floor console. (Refer to BODY (INTERIOR AND EXTERIOR) )
  6. Connect the DAB, PAB, SAB, CAB and BPT connectors.
  7. Reconnect the battery negative cable.
  8. After installing the SRSCM, confirm proper system operation:
    • Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
scientia non olet · About LEMON Manuals